I removed the weight and plastic from the underside of the foredeck stiffener. A piece of spruce was used to add some support and strength to this part of the foredeck. Epoxy was spread on all surfaces of the spruce to avoid any water damage.
Monday, February 2, 2009
Subscribe to:
Post Comments (Atom)
Blog Archive
-
▼
2009
(123)
-
▼
February
(42)
- Hull painted
- Color on the hull
- Covering up the white bottom and blue boot stripe
- White paint on the hull
- Blue Boot Stripe - II
- Blue Boot Stripe
- Hull faired, primed and ready for final paint!
- Hull pictures
- Thursday - February 12th update
- Fixed the Hull/Deck Joint
- Set Back
- RUDDER
- Back in the barn for the night
- Primed Hull
- Getting ready to prime the hull!
- Mast ram
- Booms
- Rudder
- Rudder servo
- Main sheet post
- Mast tube - cut off and sanded down
- Rudder
- Installing mast tube, sheet post
- Deck attached to the Hull
- UPDATE - February 4, 2009
- Rudder post plug
- Underside of deck
- Shroud, Backstay and Turning Block Attachment Points
- Shaping the Transom
- Inside of the hull
- Attaching structures to the hull
- Transom
- Base for Mast Tube and Sheet Post
- Rudder Servo Bracket
- Sail Servo Bracket
- Keel box stiffeners/frames
- Cutting keel box
- Keel box / Hull joint
- Removal of Keel from Keelbox/Hull
- Forward Frame
- Sail Servo Bracket
- Foredeck Stiffener
-
▼
February
(42)
No comments:
Post a Comment